Description
Easiways 25-gallon, molded dip tank incorporates a ribbed design stabilized by two
rigid molded pillars with increased durability to eliminate any bowing in tank sides.
Special features include a screen hold-down bar to keep screens submerged in the solution while soaking, an in-tank drip ledge to eliminate wasted chemical drag out (not currently seen on any other models in the industry), a sludge catch molded into the bottom of the tank to avoid screens sitting in goop and a drain for easy emptying.
This tank will hold 2-3 (23″ x 31″) frames horizontally OR (20″ x 24″) frames vertically
Tank Includes:
- Dip Tank
- Threaded drain fitting
- Built-in drip ledge
- Built-in screen hold-down bar
- Sludge catch molded into the bottom of the tank
*Dip tank does not include a lid.
Dimensions & Weight:
- Volume: 25 Gallons
- Outside Tank Dimensions without lid: 37″ W x 13″ D x 28″ H
- Inside Dimensions: 33″ W x 7″ D x 24.75″ H
- Weight: 37.0 lbs
Chemical Recommendations:
1:7 Chemical to Water Ratio using Easistrip Supra
- PT525 (25 Gallon Dip Tank)
- 4 gallons of Easistrip Supra One step Ink Cleaner & Emulsion Remover
- Up to 21 Gallons of water
Instructions:
Scrape as much ink out of your screen, dip your frame in your tank for 1-3 minutes (just enough time to soften your emulsion), bring to your washout booth and high-pressure rinse both sides of the screen. Your screen will then be ready for the stain removal process.
- Scrape as much ink off your screen as possible
- Place screen in your dip tank and let it soak for roughly 2-3 minutes
- Pull the screen out of the dip tank and allow excess fluid to drain back into the tank
- Bring your screen to your washout booth
- High-pressure rinse emulsion off the screen
- Apply Easisolv 701 screen wash & stain remover (with degreasers) to both sides of your screen and scrub
- High-pressure rinse the excess ink and stains from your screen
- Low-pressure/ flood rinse your screen to remove any excess chemical from the mesh
- Dry your screen- it will then be ready for reuse
