Multi-Trans

PRINT SETTINGS FOR OKI WHITE TONER PRINTERS • Paper & Print: Transparency, Multi-Purpose Tray • White Toner Density: +3 (Calibration at the printer panel) • Image Mode: mirror image PRINT SETTINGS FOR OKI Pro8432WT • Paper & Print: User Type 1, Multi-Purpose Tray • White Toner Density: +3 (Calibration at the printer panel) • Color Paper Settings: +2 (Set at the printer panel) PRINT SETTINGS FOR CMYK PRINTERS Only for light colored mugs • Paper & Print: Transparency (Film/Foil) or similar TRANSFER PROCESS • Preheat your mug press before use. • Position & fix the printed image to the mug using a heat resistant tape. • Put the mug in the press. • Press by using the settings below. • IMPORTANT: The timer of the mug press should not start until the mug has reached the set temperature. If your press does not do this automatically, increase the press time to 4 minutes! • Cool the mug down by dipping into cold water. Make sure the transfer media is soft before peeling. ATTENTION: At this point, the mug is very hot. Take precautions when moving the mug TIPS & TRICKS • The light marks that may appear after the application process, can be easily removed with Isopropanol. • Using the Mug Press Silicone Pad helps distribute the heat evenly around the whole mug & transfer. The pressing parameters can vary by using a silicone pad. • If you put the mug in the oven at 160°C / 320°F for 15 minutes the scratch resistance will be better

PRINT SETTINGS FOR OKI WHITE TONER PRINTERS • Paper & Print: Transparency, Multi-Purpose Tray • White Toner Density: +3 (Calibration at the printer panel) • Image Mode: mirror image PRINT SETTINGS FOR OKI Pro8432WT • Paper & Print: User Type 1, Multi-Purpose Tray • White Toner Density: +3 (Calibration at the printer panel) • Color Paper Settings: +2 (Set at the printer panel) PRINT SETTINGS FOR CMYK PRINTERS Only for light colored mugs • Paper & Print: Transparency (Film/Foil) or similar TRANSFER PROCESS • Preheat your mug press before use. • Position & fix the printed image to the mug using a heat resistant tape. • Put the mug in the press. • Press by using the settings below. • IMPORTANT: The timer of the mug press should not start until the mug has reached the set temperature. If your press does not do this automatically, increase the press time to 4 minutes! • Cool the mug down by dipping into cold water. Make sure the transfer media is soft before peeling. ATTENTION: At this point, the mug is very hot. Take precautions when moving the mug TIPS & TRICKS • The light marks that may appear after the application process, can be easily removed with Isopropanol. • Using the Mug Press Silicone Pad helps distribute the heat evenly around the whole mug & transfer. The pressing parameters can vary by using a silicone pad. • If you put the mug in the oven at 160°C / 320°F for 15 minutes the scratch resistance will be better